Item needed:
JDM leopard Trunk Emblem
Tools needed:
14 mm socket.
maybe a screw driver.
-----------------------
Remove the liner that is on the top of the trunk, to expose the wires for the sensors near the emblem, unplug.
-start off by unbolting the trunk latch. (2 bolts)
-wiggle it out to pass the sensor (the sensor is for the trunk light)
-Unbolt trunklight sensor (1 bolt)
There are 2 things that are near the emblem.
1.emblem sensor
2.shim (holds in place)
this is how everything on the back of the emblem behind the trunk
the emblem sensor has a C shaped clamp around the emblem.
With the shim, you'll have to wiggle it left and right to get it off.
After the shim, the emblem will come out with minimal resistance
----------------------------------------------------------------
the trunk should be clean and empty.
put the emblem on and the shim after.
*the emblem sensor*
the emblem sensor will not sit snug on the Leopard emblem
it will fit on, but not snug. You can see where the sensor would be
be and the difference on the emblem's post.
-bolt the trunk light sensor back
-bolt the trunk latch back on
-plug the wires
-put the trunk liner back on..
Test the trunk pop switch
Test the keys
your done.
note - i had 2 trunk emblems and one had wires to hook up. I did not hook these up since I dont know what it does.
emblem wires.
